Netfer Heroto-75 Application Guide

Make sure that the surface to be treated is cold, clean and dry.

Spread enough paste to the surface, spread it on the surface at low (1000) RPM.

Apply it until the scratches disappear, BETWEEN 3000-4500 RPM depending on the surface and the condition of the scratches.

Manual application should be made by using COTTON with oval movements at right angles to scratches.

IT SHOULD BE USED WITH MEDIUM OR SOFT POLISH SPONGE.

It does not contain silicone and filling material.

It removes the scratches by eroding, not by filling.

It removes capillary scratches and fine brush marks.

It removes sanding traces of 3000 sand and above.

It does not dull the paint.

It does not cause excessive dusting.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.